How do I install the Pass & Seymour ‎WWRL10WHCCV2 Smart Wi-Fi Switch? (Pass & Seymour ‎WWRL10WHCCV2 Smart Wi-Fi Switch Installation Manual)

Answer

manuals.plus

Jan 28, 2025 - 10:21 AM

To install the Pass & Seymour ‎WWRL10WHCCV2 Smart Wi-Fi Switch, please follow the steps below:

1. Turn off power at your breaker to ensure safety during installation.

2. Identify the wires in the electrical box where you will be installing the smart switch.

3. Remove the existing switch. It may be helpful to take a photo of how the old switch was wired for reference.

4. Wire the smart switch:
- Connect the smart switch white NEUTRAL wire to the neutral wire(s) in the box. Twist and cap them off with the red wire nut.
- Connect the smart switch LOAD wire to the load wire in the box.
- Connect the smart switch HOT wire to the hot wire(s) in the box.
- Connect the smart switch green GROUND wire to the ground wire(s) in the box.
- Cap the yellow traveler wire with a wire nut. If more than one switch controls the light, connect the smart switch yellow TRAVELER wire to the wire going to the other switch.

5. Test the smart switch to ensure it is properly installed.

6. Download the Legrand Smart Lights App on your smartphone.

7. Login or create a Legrand account to enable control from your phone.

8. Click "add a device" in the app and scan the barcode on the front of the smart switch to connect it to the app.

For more detailed instructions and illustrations, please refer to the Pass & Seymour ‎WWRL10WHCCV2 Smart Wi-Fi Switch installation manual.

Note: A neutral wire is required for installation. The smart switch can be installed in a 3-way wiring situation and does not require a smart hub.