User Manual Q&AAnswer
Jan 28, 2025 - 12:31 AM
To install the Fanimation FP6729BMWW Xeno Wet Ceiling Fan, follow these steps:
1. Gather the necessary tools, including a Phillips head screwdriver, wire stripper, stepladder, 4-blade screwdriver, and four wire connectors.
2. Ensure that you have the appropriate wiring outlet box and box connectors required by local code. The minimum wire size should be a 3-conductor (2-wire with ground).
3. Unpack the fan and check off each step in the user manual as you complete them.
4. Determine the appropriate direction for using the ceiling fan based on the season. In the summer, use the fan in the counterclockwise direction to create a wind-chill effect. In the winter, reverse the motor and operate the fan at low speed in the clockwise direction to force warm air down into the space.
5. Ensure that you have the necessary electrical and structural requirements. The fan requires a grounded electrical supply line of 120 volts AC, 60 HZ, and a 15 Amp Circuit. Use a fan-rated outlet box to support the weight and motion of the fan.
6. Assemble the fan by cutting off excess lead wire, attaching the safety cable to the ceiling joist, securely attaching the hanger bracket to the ceiling junction box, and seating the downrod/hanger ball assembly on the hanger bracket.
7. Wire the fan by connecting the green wires from the hanger bracket and downrod to the bare (ground) wire using wire connectors. Connect the black wire from the receiver unit marked "AC IN L" to the black supply wire using a wire connector. Carefully push the leads into the outlet box, with the white and green leads on one side and the black leads on the other side.
8. Install the canopy housing by removing one shoulder xxxx in the hanger bracket, loosening the second shoulder xxxx , and attaching and tightening the canopy xxxx cover over the shoulder screws.
9. Assemble the fan blades by positioning them over the threaded posts and securing them with the serrated head screws and flat washers.
10. Assemble the light kit by attaching it to the motor assembly support bracket using the key slots. Connect the LED assembly to the motor assembly if using the light kit option. Secure the glass or plastic cap to the light kit.
11. Restore electrical power to the outlet box, install the battery in the hand-held remote transmitter, and set the remote code using the dip switches.
12. Operate the fan by using the remote control functions. If you want to change the direction of the airflow, turn off the fan, wait for the blades to stop turning, and slide the reverse switch on top of the motor assembly to the opposite position.
For more detailed instructions and illustrations, refer to the Fanimation FP6729BMWW Xeno Wet Ceiling Fan user manual.
Add New Comment