Answer
Jan 28, 2025 - 12:00 AM
To program the keypad on the Honeywell 8832401S Safes & Door Locks, follow these steps:
1. Wake up the lock by pressing any button on the keypad.
2. Input the Administrator Passcode (AP) and wait for a green light and beep.
3. To turn on/off the Auto-Lock function, input the AP, followed by "5". Then input the desired time (20 - 900 seconds) or "00" to turn off Auto-Lock. Wait for a green light and beep.
4. To turn off the sound, input the AP, followed by "6" and "1". Wait for a green light and beep.
5. To turn on the sound, input the AP, followed by "6" and "2". Wait for a green light and beep.
6. To restore factory settings, press the reset button on the PCB board until you hear one beep. Release the button, and after three seconds, you will hear a second beep indicating that the lock has been reset to the factory settings.
7. To add an administrator, use the Honeywell App and connect to the lock by pressing any button on the keypad.
8. To customize passcodes received from the app, input the AP, followed by "1". Then input the Received Passcode (RP), followed by the New Passcode (NP), and repeat the NP. Wait for a green light and beep.
9. To enable/disable Auto-Lock, input the AP. To disable Auto-Lock, unlock the door with the correct password and turn the locking xxxx to the locked position within 10 seconds. Wait for more than 2 seconds, or press the button on the keypad to enable Auto-Lock.
10. To enable Vacation Mode, input the AP, followed by "10" and "1". Wait for a green light and beep.
11. To disable Vacation Mode, press the button for 3 seconds and input the AP. Wait for a green light and beep.
Please refer to the user guide for additional programming options and details.
Add New Comment