User Manual Q&AAnswer
Jan 27, 2025 - 10:52 PM
To connect the Lomota MSG100 Garage Door Opener Remote to your existing garage door opener, please follow these steps:
1. Download the wise home app: Start by downloading the wise home app on your smartphone. This app will be used to control and configure the garage door opener.
2. Power on the device: Plug in the Lomota MSG100 Garage Door Opener Remote and power it on.
3. Open the wise home app: Open the wise home app on your smartphone and follow the inbuilt setup wizard for configuration. Make sure your smartphone is connected to your home WiFi network.
4. Connect the sensor cable: Connect the sensor cable to the Lomota MSG100 Garage Door Opener Remote. Move the sensor to check if it is functional. Please ensure that the distance between the two sensors is less than 1 inch when the garage door is closed, and the two sensors are well separated when the garage door is open.
5. Power off your existing garage door opener: Turn off the power to your existing garage door opener.
6. Connect the signal control cable: Connect the other end of the signal control cable to the two terminals that connect to the wall button of your existing garage door opener. The wire order does not matter in this step.
7. Deploy the device: It is recommended to deploy the Lomota MSG100 Garage Door Opener Remote on the top of your existing garage door opener. Use the provided double-sided adhesive tapes for fixation if necessary.
Once the above steps are completed, your Lomota MSG100 Garage Door Opener Remote should be successfully connected to your existing garage door opener. You can now control your garage door using the wise home app or the physical button on the remote.
For more detailed instructions and information, please refer to the Lomota MSG100 Garage Door Opener Remote USER MANUAL provided in the link: [USER MANUAL](https://manuals.plus/wp-content/uploa...)
Add New Comment