User Manual Q&AAnswer
Jan 27, 2025 - 10:41 PM
Sure! Here is a step-by-step guide on how to install the Kwikset 99140-111 Convert Smart Lock Conversion Kit, based on the provided user manual:
1. Begin with your smart home app: If you will be using a smart home app with your lock, download the app and set up your controller or hub before proceeding further with lock installation.
2. Prepare your door:
- Make sure your existing deadbolt is compatible. If you have a standard deadbolt mounted separately from the handle below it, it is compatible with Kwikset Convert.
- Make sure your door is aligned before proceeding with the installation.
- Measure to confirm that your door is either 1-3/8" or 1-3/4" (35 mm or 44 mm) thick.
- Make sure your door is open and extend your latch bolt. Make sure your key is NOT in the deadbolt exterior.
- Optional: Secure your deadbolt exterior with masking tape.
- Remove all existing deadbolt hardware from the interior side of your door.
3. Determine the parts needed for your door.
4. Install the mounting plate and test your latch:
- Place the mounting plate on the door so that the torque blade inserts through the center hole.
- Secure the mounting plate with the mounting screws.
- Remove the masking tape from the exterior deadbolt, and insert your key and test the latch for smooth operation.
- Remove your key and make sure the bolt is fully extended.
5. Install the interior assembly:
- Remove the interior cover and battery pack.
- Install the adapter on the interior assembly.
- Align the adapter with the torque blade and push the interior assembly onto the mounting plate.
- Secure with two (2) interior assembly screws.
6. Perform the door-handing process:
- Install 4 AA batteries in the battery pack.
- Make sure the door is open. Insert the battery pack while PRESSING AND HOLDING the Program button.
- The Status LED will flash red and green, and the lock will beep. Press and release the Program button again.
- The latch bolt will retract and extend on its own to learn the orientation of the door. Did the Status LED turn green or red?
7. Confirm the lock status:
- The Status LED blinks every six seconds to communicate whether the door is locked or unlocked.
- If the Status LED is displaying the wrong lock status, flip switch #4.
8. Pair the lock with your smart home system:
- Initiate the pairing process through your smart home system (either through your smart home app, at your panel, or at your controller or hub). Refer to your smart home system instructions for more information.
- When prompted by your smart home system to initiate pairing at the lock, press button “A” on the lock interior four times.
- If successful, re-name the lock in your system (if applicable). If unsuccessful, press button “B” nine times. Perform steps 8A-8C again.
- If still unsuccessful, follow your smart home system's instructions to remove (exclude/unpair) the lock from any other network. Then perform steps 8A-8C again.
9. Install the interior cover.
Please note that this is a general overview of the installation process. For more detailed instructions and illustrations, please refer to the provided user manual.
Add New Comment