User Manual Q&AAnswer
Jan 27, 2025 - 05:17 AM
To install and mount the ITC Look Backlit Mirror Power Supply, please follow the instructions provided in the manual:
1. Mounting to Contractor Supplied Blocking:
a. Determine the installation location and xxxx the power supply box to the contractor-supplied blocking.
2. Barrel Connector Instructions:
a. Punch out the left or right hole on the power supply box and place the supplied grommet in place.
b. Feed the barrel connector through the hole. Note that the barrel connector will come inside the power supply box.
3. Mounting to the Back of Elio Mirror:
a. Remove the brackets from the power supply box.
b. Use the pre-installed brackets on the back of the Elio backlit mirror.
c. xxxx in the power supply using the provided screws.
4. Wiring & Grounding Instructions:
a. Punch out one of the three holes on the power supply box.
b. Bring the incoming AC power wires to the box and make all connections inside the power supply box following the wiring diagram provided.
Optional: Dimming Wiring Instructions:
a. Punch out one of the three holes on the power supply box.
b. Bring the incoming dimming wires to the box and make all connections inside the power supply box following the wiring diagram provided.
If you encounter any issues during installation or have further questions, please refer to the troubleshooting section in the manual or contact ITC using the provided contact information:
ITC Contacts:
- Address: 3030 Corporate Grove Dr., Hudsonville, MI 49426
- Phone: 616.396.1355
- Website: itc-us.com
For warranty information, please visit www.itc-us.com/warranty-return-policy.
Add New Comment