User Manual Q&AAnswer
Jan 27, 2025 - 03:39 AM
To start the charging process with the juice Charger Me 3, follow these steps:
1. Take the vehicle-end connector from the holder and remove the protective rubber cap from the vehicle-end connector.
2. Plug the (Type 2) vehicle-end connector into the vehicle's charging socket. Once firmly coupled to the vehicle, this status is confirmed by the slowly blinking "2" symbol on the function display.
3. Activate the charge using one of the two pre-programmed RFID cards supplied with the charging equipment. This activation is confirmed by the slowly blinking "3" symbol on the function display.
4. The charging process will begin, indicated by the slowly blinking "4" symbol on the function display.
Remember to stop the charging process at the controls inside the vehicle and remove the vehicle-end connector from the car when you're done charging.
Add New Comment