User Manual Q&AAnswer
Jan 27, 2025 - 02:23 AM
To pair the Xblitz Uni Pro 3 wireless earbuds with your phone, follow these steps:
1. Remove the insulation tape from the earphones and place them back into the charging case to charge both earphones. If the earphones do not charge in the case, connect the USB power cord to the power port of the case.
2. After taking the earphones out of the case, a blue LED should flash on both of them, indicating that the device has turned on.
3. If the earphone LEDs are alternating between blue and red, the device is ready to pair. Turn on Bluetooth connectivity on your phone and select "Xblitz UNI PRO 3" from the list of available devices to connect to your phone.
4. Once the headphones are paired with your phone, the LEDs on them will stop blinking, and your phone will display the corresponding information, such as "The device is connected, 100% battery left."
5. The earphones will automatically turn off when they are inserted back into the case. They will also automatically turn off after 300 seconds of inactivity.
6. To use the earphones again, simply take them out of the case, and they will automatically turn on and pair with your phone.
If pairing fails, you can restore the device to factory settings by turning off the earphones and then holding the buttons on both of them for 8 seconds. After turning on the device again, it should pair up automatically.
Please refer to the user manual for more detailed instructions and illustrations.
Add New Comment