User Manual Q&AAnswer
Jan 27, 2025 - 02:02 AM
To install the MCOHOME MH-S314 Touch Panel Switch, please follow these steps:
1. Cut off the power supply at the circuit breaker or fuse before installation to avoid any accidents.
2. Prepare for the installation by reading all instructions and documentation provided with the switch.
3. Wiring: Connect the Hot Line to the "L" terminal, the Neutral Line to the "N" terminal, and the Load wire to the "L1-L4" terminals. If you need a higher output, consider choosing model MH-S311H or MH-S312H instead.
4. Installation:
- Remove the steel frame from the device and secure it onto the junction box with two screws.
- Insert all wires into the correct terminals and tighten the screws.
- Attach the wired device on the designated points of the steel frame and then push the whole device into the junction box.
- Confirm that the device is securely mounted, then power it on and it will be ready to operate.
Please note that it is important to have a qualified electrician with an understanding of wiring diagrams and knowledge of electrical safety complete the installation inside the main circuit box.
Add New Comment