How do I assemble the DEDEMAN US62 Executive Office Chair? (DEDEMAN US62 Office Chair Instruction Manual)

Answer

manuals.plus

Jan 27, 2025 - 01:45 AM

According to the DEDEMAN US62 Executive Office Chair Instruction Manual, here are the steps to assemble the chair:

1. Unpack all the parts and lay them out on a clean and flat surface.
2. Attach the wheels to the base of the chair. Insert each wheel into the designated hole and push firmly until it clicks into place.
3. Attach the gas lift cylinder to the base. Insert the cylinder into the center hole of the base and push it in until it locks.
4. Place the seat onto the gas lift cylinder. Line up the holes on the bottom of the seat with the cylinder and push down firmly until it locks into place.
5. Attach the backrest to the seat. Line up the holes on the backrest with the holes on the seat and insert the screws provided. Tighten the screws securely using the appropriate tool (usually an Allen wrench).
6. Attach the armrests to the seat. Line up the holes on the armrests with the holes on the seat and insert the screws provided. Tighten the screws securely using the appropriate tool.
7. Adjust the height of the chair by pulling the lever located under the seat. Lift or lower the seat to your desired height and release the lever to lock it in place.
8. Adjust the tilt tension by turning the xxxx located under the seat. Turn it clockwise to increase tension or counterclockwise to decrease tension.
9. If your chair has additional features such as adjustable lumbar support or headrest, refer to the specific instructions provided in the manual for those components.

Please note that the exact assembly steps may vary slightly depending on the specific model of the DEDEMAN US62 Executive Office Chair. It is always recommended to refer to the instruction manual that came with your chair for the most accurate and detailed instructions.