User Manual Q&AAnswer
Jan 27, 2025 - 01:37 AM
To remove the door panels and install the Soundskins 239BRONCO Bronco Kit, follow these steps:
1. Start by locating the fastening hardware on the door panels. There will be one behind the door handle under a plastic cover, one behind the door grab handle that you will have to pop out to reveal, and 2 at the bottom right corner of the door panels. Use a 7 mm socket to remove these fasteners.
2. Use a panel/trim tool to pry the panel off the door, starting from the bottom right corner. Be careful not to break any clips or mounting hardware.
3. Slowly pull the door panel away. There will be 2 plug clips that need to be released, as well as a wire plug to disconnect. Set the door panel aside.
4. Unhook all plugs, remove the vapor barrier, and clean the car metal surface using a microfiber cloth and acetone or other cleaning solution. The surface needs to be clean to ensure proper adhesive contact.
5. Start applying the door pieces by peeling off the backing paper starting at the top. Tack the piece onto the door and work your way down, pressing down the material and pulling down the backing paper more as you go along. Make sure to feed the harnesses through the proper holes and ensure all holes are aligned properly before pressing the entire piece down. Repeat this process for all 4 doors.
Note: For more detailed instructions and visuals, you can refer to the Soundskins 239BRONCO Bronco Kit Instruction Manual or watch the instructional video by scanning the provided QR code.
Add New Comment