User Manual Q&AAnswer
Jan 26, 2025 - 11:37 PM
To install the Meross MSS510 Smart Light Switch, please follow the steps below:
1. Make sure your traditional switch is a single pole switch. This smart switch is not compatible with 3-way or 4-way switches.
2. Place your smartphone near the traditional switch to ensure it is covered by a strong Wi-Fi signal.
3. Turn off the power at the circuit breaker that controls the switch. Use a voltage detector to double-check that the power is off.
4. Remove the faceplate and pull out the traditional switch. Locate the neutral wire (usually white) in your electrical box. This smart switch requires a neutral wire to work.
5. Unscrew the wires and connect them according to the provided picture or the instructions in the Meross app.
6. Push the smart switch back into the box and turn the power on at the circuit breaker. If the switch works manually and the LED is flashing amber and green, you have successfully installed it. If not, turn off the power and check the wiring.
7. For more detailed information, refer to the Meross app.
Note: If you are unfamiliar with electrical codes or uncomfortable performing the installation, it is recommended to call a qualified electrician for assistance.
Add New Comment