User Manual Q&AAnswer
Jan 26, 2025 - 11:01 PM
To install the Custom Dynamics Magic Strobes Brake Flasher on your motorcycle, please follow these steps:
1. Secure your motorcycle on a level surface and remove the seat.
2. If you have a Chief model, remove the 4 rear fender panel mounting bolts and remove the rear fender panel.
3. Disconnect the negative [-] battery cable from the battery.
4. Locate and unplug the rear lighting connector to the rear fender under the seat. For all models except Chief models, the rear lighting connector is located on the right side near the rear fender. For Chief models, refer to Photo 3 in the manual.
5. Plug the Magic Strobes module in-line into the rear lighting harness plug and the bike's main wiring harness plug.
6. Reconnect the battery's negative cable to the negative [-] terminal of the battery.
7. Select the desired pattern on the dial with the power off. Refer to Page 2 of the manual for pattern information.
8. Check the operation by pressing the brake and confirming the brake strobe pattern.
9. To change the pattern, turn off the bike and change the dial to the desired pattern.
10. Locate a secure place for the Magic Strobes unit that will not interfere with the secure placement of the seat. Secure it with the enclosed tie-wraps so that the unit will not move.
11. Reinstall the seat and rear fender panel if they were removed.
Please note that it is important to secure the module after installation in a safe area away from any moving parts and out of the way of normal operation of the bike. Use the enclosed tie-wraps to secure it. Custom Dynamics is not liable for damage as a result of improperly securing or failing to secure the module.
For any further questions or assistance, you can contact Custom Dynamics at 1(800) 382-1388.
Add New Comment