User Manual Q&AAnswer
Jan 26, 2025 - 10:28 PM
To change the lighting effects on the IMOSHION A1 Disco lamp, you can use the remote controller. Here is a step-by-step guide:
1. Make sure to remove the plastic protector at the bottom of the remote before use.
2. Aim the remote controller towards the IR signal receiver on the lamp without any barriers.
3. Press the "Mode" button on the remote to cycle through different effect modes. Each press will change the effect.
4. The "Effect" button on the remote allows you to select specific colors or color combinations. Pressing this button will cycle through different options.
5. The "Content" button on the remote is used to control the content of the lighting effects. Pressing this button will change the content of the selected effect.
6. The "MUSIC 1", "MUSIC 2", and "MUSIC 3" buttons are used for sound control. "MUSIC 1" activates sound-activated on/off, "MUSIC 2" enables sound-activated color changing, and "MUSIC 3" triggers sound-activated strobe lighting.
7. The "FLASH" button is for strobe control. Pressing this button will activate the strobe lighting effect.
8. The "+" and "-" buttons on the remote control the motor rotating speed. Pressing "+" will speed up the rotation, while pressing "-" will slow it down.
Please note that there might be a 1-second delay when switching to other lighting patterns. The remote control can be used within a 5-meter distance from the lamp.
For more detailed instructions and safety information, please refer to the IMOSHION A1 Disco lamp User Manual.
Add New Comment