User Manual Q&AAnswer
Jan 26, 2025 - 10:21 PM
To connect speakers to the MA60BT amplifier, follow these steps:
1. Determine the type of speaker system you have. The MA60BT amplifier supports both low-impedance (4, 8, or 16 Ohms) and high-impedance (70V or 100V) speaker systems.
2. For low-impedance speakers, use speaker wire to connect the positive (+) and negative (-) terminals of each speaker to the corresponding terminals on the amplifier. Make sure to match the impedance of the speakers with the selected impedance xxxx terminal on the amplifier.
3. For high-impedance speakers, connect the positive (+) terminal of the first speaker to the "70V" or "100V" output terminal on the amplifier. Connect the negative (-) terminal of the first speaker to the "COM" terminal on the amplifier. Then, connect the positive (+) terminal of each subsequent speaker in parallel to the positive (+) terminal of the previous speaker. Connect the negative (-) terminal of each subsequent speaker to the "COM" terminal on the amplifier.
Note: When using high-impedance speakers, make sure they are equipped with a 70V/100V transformer. The total wattage of all speakers connected to the amplifier should not exceed the maximum RMS output power of 60W to avoid damaging the amplifier.
Refer to the "AMPLIFIER OPERATION GUIDE" section of the instruction manual for more information on connecting and setting up the amplifier.
Add New Comment