User Manual Q&AAnswer
Jan 26, 2025 - 09:42 PM
To assemble the DRIFT DR50 Gaming Chair, please follow the steps outlined in the instruction manual provided with the product. Here is a step-by-step guide on how to assemble the chair:
1. Start by unpacking all the parts and lay them out in an organized manner.
2. Attach the five-star base to the gas lift cylinder by inserting the cylinder into the center hole of the base. Ensure that it is securely attached.
3. Take the seat plate and align it with the gas lift cylinder. Insert the cylinder into the hole on the bottom of the seat plate. Make sure it is firmly connected.
4. Attach the backrest to the seat plate by sliding the metal brackets on the backrest into the corresponding slots on the seat plate. Apply some pressure to ensure a tight fit.
5. Locate the armrests and attach them to the seat plate. Align the holes on the armrests with the holes on the seat plate and use the provided screws to secure them in place. Tighten the screws firmly but do not overtighten.
6. Once the chair is fully assembled, adjust the height of the chair by using the lever located under the seat. Pull the lever up to raise the chair or push it down to lower it. Release the lever to lock the chair at the desired height.
7. If your chair comes with additional features such as a headrest or lumbar support cushion, attach them according to the instructions provided in the manual.
Please note that this is a general guide, and it is important to refer to the specific instructions and diagrams in the DRIFT DR50 Gaming Chair instruction manual for accurate assembly.
Add New Comment