How do I use the Pedro S 6450681 Burrito Tool Kit to install or remove a tire? (PEDRO S 6450681 Burrito Tool Kit User Guide)

Answer

manuals.plus

Jan 25, 2025 - 05:32 AM


To install or remove a tire using the Pedro S 6450681 Burrito Tool Kit, you will need to use the Tire Levers and the Multi Spoke Wrench.

1. Installation:
   - Start by deflating the tire completely.
   - Insert one end of a Tire Lever between the tire bead and the rim, near the valve stem.
   - Use the lever to pry the tire bead over the rim, working your way around the wheel until one side of the tire is completely off the rim.
   - Place the tire onto the rim, starting at the valve stem, and make sure the tire bead is seated evenly on the rim.
   - Use the Multi Spoke Wrench to tighten the spokes evenly, ensuring the tire is centered and aligned with the rim.
   - Inflate the tire to the recommended pressure.

2. Removal:
   - Start by deflating the tire completely.
   - Insert one end of a Tire Lever between the tire bead and the rim, near the valve stem.
   - Use the lever to pry the tire bead over the rim, working your way around the wheel until both sides of the tire are completely off the rim.
   - Carefully remove the tire from the rim, making sure not to damage the inner tube.
   - If necessary, use the Multi Spoke Wrench to loosen the spokes evenly, allowing easier removal of the tire.

Note: It is important to follow proper tire installation and removal techniques to avoid damaging the tire, rim, or inner tube. Always refer to the manufacturer's instructions for your specific tire and rim combination.