User Manual Q&AAnswer
Jan 25, 2025 - 04:05 AM
To install the Niles CSF48P Passive Bar System, follow these steps:
1. Cut a rectangular opening in the drywall according to the provided cutout template.
2. Locate and mark the studs in the wall where the system will be installed.
3. Route the speaker wires from the AV receiver to each speaker module.
4. Hang the speaker modules on the In-Wall Mounting System using the provided "L" brackets.
5. Connect the speaker wires to the terminals on each speaker module.
6. Install the In-Wall Power Supply Box (if applicable) near an AC outlet and connect the 24V DC power cable to the Amplifier Module.
7. Route the necessary cables (Toslink Optical, stereo 3.5mm to dual RCA, HDMI, etc.) from the TV to the Amplifier Module.
8. Position the Amplifier Module and optional SW-T in the In-Wall Mounting System using the "L" brackets.
9. Connect the speaker wires and other cables to the Amplifier Module.
10. Secure the In-Wall Mounting System by tightening the screws on the xxxx Down Slide Brackets and Clamp Down End Brackets.
11. Install the In Between Covers and Joiners to fill the empty spaces in the In-Wall Mounting System.
12. Attach the Speaker Grille magnetically to the In-Wall Mounting System and adjust its position as needed.
13. Test the system before completing the installation.
For more detailed instructions and illustrations, refer to the Niles CSF48P Passive Bar System User Guide.
Add New Comment