How do I install the DENALI HMT.23.10100 Harley Davidson Pan America Horn Mounting Bracket? (DENALI HMT.23.10100 America Horn Mounting Bracket Instruction Manual)

Answer

manuals.plus

Jan 25, 2025 - 03:50 AM


To install the DENALI HMT.23.10100 Harley Davidson Pan America Horn Mounting Bracket, please follow the steps below:

1. Start by removing the factory bolts from the mounting locations on your bike. Note that the right side flanged bolt from the frame will be reused to mount the bracket.

2. Mount the horn bracket using the provided M8x30mm Hex Head Bolt, M8 Washer, M8 Spacer, and the factory flanged bolt from the bike's frame that was previously removed.

3. To install the horn, use the hardware supplied with the SoundBomb Horn and attach it to the bracket. Use a 13mm wrench to tighten the nut on the back side of the mount.

4. Before fully tightening the horn, you can make small adjustments by slightly rotating the horn to better match the profile of your bike. The horn should not exceed 10 degrees of tilt and should be as close to 90 degrees upright as possible. Once you are happy with the position, make sure to fully tighten the horn.

Please note that DENALI products should always be installed by a qualified motorcycle technician. If you are unsure of your ability to properly install the product, it is recommended to have it installed by your local motorcycle dealer. DENALI takes no responsibility for damages caused by improper installation.

For further assistance or if you have any additional questions, you can contact DENALI's gear experts at 401.360.2550 or visit their website at www.denalielectronics.com.