User Manual Q&AAnswer
Jan 24, 2025 - 09:35 PM
To install the DYNOJET PC6-16045 Power Commander 6, please follow the steps below:
1. Remove the main seat and rear solo seat cover, as well as the left-hand side fairing.
2. Prop up the front of the fuel tank.
3. Locate the connector on the left-hand side of the bike and unplug it.
4. Plug the GREY connectors from the PC6 in-line with the stock connectors.
5. Route the pair of 2-pin PC6 connectors inside the frame and towards the front of the engine, keeping the wires between the front cylinder and the radiator.
6. Locate and unplug the stock Crank Position Sensor connectors, which can be found inside a black rubber boot above the bike's horn.
7. Plug the pair of 2-pin PC6 connectors in-line with the stock Crank Position Sensor connectors.
8. Attach the ground wire from the PC6 to the negative side of the battery.
9. Use the supplied self-adhesive Velcro to attach the PC6 to the rearmost area of the inner fender. Clean both surfaces before attaching the Velcro using the supplied alcohol swab.
For more detailed information and illustrations, please refer to the installation guide provided with the DYNOJET PC6-16045 Power Commander 6.
Note: It is recommended to download the latest maps from the Dynojet website at dynojet.com/tunes for optimal performance.
If you have any further questions or need additional assistance, please consult the installation guide or contact DYNOJET customer support at 800-992-4993.
Add New Comment