User Manual Q&AAnswer
Jan 24, 2025 - 08:43 PM
Here is a step-by-step guide on how to install the DYNOJET PC6-12012 Power Commander 6:
1. Start by turning off the ignition before beginning the installation.
2. Remove the seat and fuel tank covers.
3. Remove the fuel tank or prop it up out of the way.
4. Remove the left and right side fairings.
5. Use the supplied Velcro strips to secure the PC6 in the tail section. Clean both surfaces with the supplied alcohol swab before attaching the Velcro.
6. Route the PC6 harness down the left side of the bike, underneath the fuel tank bracket, and towards the throttle bodies.
7. Attach the ground wire from the PC6 to the negative (-) terminal on the battery using the small ring lug.
8. Unplug the stock wiring harness from each fuel injector.
9. Plug the PC6 harness in-line with the stock wiring harness and each fuel injector. The PC6 harness colors correspond to the cylinders: Orange for cylinder #1 (left), Yellow for cylinder #2, Green for cylinder #3, and Blue for cylinder #4 (right).
10. Locate the Throttle Position Sensor (TPS) connector from the throttle bodies on the left, inside of the frame.
11. Use the supplied posi-tap to attach the grey wire from the PC6 to the stock white/grey wire on the TPS connector. It is recommended to use dielectric grease on these connections.
12. Use the supplied posi-tap to attach the blue/white wire from the PC6 to the stock purple/black wire of the gear position sensor connector. This connector is located under the fuel tank to the left, rear of the frame. Use the middle purple/black wire on this connector.
13. Reinstall the fuel tank, bodywork, and the seat.
14. Finally, download the latest map files from the DYNOJET website at dynojet.com/tunes.
Please refer to the installation guide provided with the DYNOJET PC6-12012 Power Commander 6 for more detailed instructions and diagrams.
Add New Comment