User Manual Q&AAnswer
Jan 24, 2025 - 10:18 AM
To activate the on the Philips 3200 Fully Automatic Espresso Machine, please follow these steps:
1. Make sure the machine is switched on.
2. Shake the AquaClean water filter for about 5 seconds.
3. Immerse the filter upside down in a jug with cold water and shake/press it.
4. Insert the filter vertically onto the filter connection in the water tank. Press it down to the lowest possible point.
5. Fill the water tank with fresh water and place it back into the machine.
6. If attached, remove the LatteGo or milk frother.
7. Place a bowl under the hot water spout/milk frother.
8. Press and hold the AquaClean icon for 3 seconds. The start light will start pulsing.
9. Press the start/stop button to start the activation process.
10. Hot water will be dispensed from the hot water spout/milk frother for approximately 3 minutes.
11. When the activation process is finished, the blue AquaClean light will go on to confirm that the AquaClean water filter has been activated correctly.
Please note that it is important to prepare the AquaClean water filter by soaking it in water before activation. This helps to prevent air from being drawn into the machine instead of water, which can cause noise and prevent the machine from brewing coffee properly.
Add New Comment