User Manual Q&AAnswer
Jan 24, 2025 - 05:36 AM
To install the nVent HOFFMAN Panel in an enclosure, please follow these steps:
1. Ensure that the panel size matches the enclosure size. The nVent HOFFMAN Panel fits a 400x200mm enclosure.
2. Remove the enclosure body opening cover or door to access the installation area.
3. Position the nVent HOFFMAN Panel in the desired location within the enclosure body opening.
4. Align the panel's mounting holes with the corresponding holes in the enclosure.
5. Insert M6 fasteners (not included) through the panel's ground hole and into the enclosure's mounting holes.
6. Tighten the fasteners securely to ensure proper installation and stability.
7. Once the panel is securely fastened, you can proceed with installing your controls and instruments onto the panel.
Please note that the nVent HOFFMAN Panel is made of mild steel and has a galvanized finish. It is unpainted, allowing you to customize its appearance if desired.
For further information or specific instructions, please refer to the nVent HOFFMAN Panel User Guide or contact nVent customer support at 763.421.2240.
Add New Comment