How do I install the nVent HOFFMAN CDACCDR Drive Access Door on my Concept HMI Enclosure Type 12? (nVent HOFFMAN Drive Access Enclosure Type 12 User Guide)

Answer

manuals.plus

Jan 24, 2025 - 05:30 AM

To install the nVent HOFFMAN CDACCDR Drive Access Door on your Concept HMI Enclosure Type 12, please follow these step-by-step instructions:

1. Ensure that you have the necessary tools and hardware provided in the package, including the installation template.

2. Start by positioning the drive access door on the desired location of the enclosure. Make sure it aligns properly with the internal disk drive.

3. Use the installation template provided to mark the mounting hole locations on the enclosure. This will ensure accurate placement of the drive access door.

4. Once the holes are marked, remove the drive access door and set it aside.

5. Using the appropriate tools, drill holes at the marked locations on the enclosure. Be careful not to damage any internal components.

6. After drilling the holes, place the drive access door back onto the enclosure, aligning the mounting holes with the drilled holes.

7. Secure the drive access door to the enclosure using the included hardware. Ensure that all screws or bolts are tightened securely.

8. Check that the drive access door opens and closes smoothly without any obstructions.

9. The drive access door comes with a key-locking latch. If desired, insert the key into the latch and turn it to lock or unlock the door.

10. Finally, verify that the drive access door is properly installed and aligned. It should maintain the NEMA Type 12 rating of the enclosure.

Please refer to the nVent HOFFMAN CDACCDR Drive Access Door User Guide for any additional information or specific instructions related to your product.