User Manual Q&AAnswer
Jan 24, 2025 - 05:06 AM
To install the ITC 81400 Series Drink Holder, follow these steps:
1. Determine the installation location and drill a 3-5/8" hole using a hole saw. Note that for part #81427 & 81430, you will need to drill a 4" hole.
2. If you are installing a standard drink holder, proceed to step 3. If you are installing a lit drink holder, follow the wiring instructions provided below.
3. For adhesive mount drink holders, simply remove the paper backing and press the holder in place. For xxxx mount cup holders, use the provided screws to secure the holder in place. For blind mount holders, tighten the screws until the tabs flip out, and then replace the decorative ring.
Wiring Instructions for VersiColor RGB/RGBW Option:
- Note: The 81433 USB drink holder has a 2.1A charging speed and will come standard with DT connectors with the following pin positions:
Single Color:
Slot 1: BK/BL
Slot 2: BK/WH
Slot 3: BK/BL
RGBW:
Slot 1: BK/RD
Slot 2: BK/WH
Slot 3: BK/BL
Slot 4: WH/BL
Slot 5: WH/BL
Slot 6: BK/WH
Please refer to the product manual or contact ITC directly for any warranty information or return policy details. You can visit their website at www.itc-us.com/warranty-return-policy or contact them at the provided phone number: 616.396.1355.
Add New Comment