User Manual Q&AAnswer
Jan 24, 2025 - 04:42 AM
To wire the ITC 69600 Series Courtesy Light, please follow the instructions provided in the manual. Here is a step-by-step guide:
1. Determine the installation location for your light and drill a 2" hole using a hole saw.
2. Refer to the wiring diagrams provided in the manual for your specific version of the light (two-wire or three-wire).
3. If using a two-wire version, a standard switch can be used. The light should be turned off and on to cycle through the colors. If the light is off for more than 30 seconds, it will restart the cycle.
4. If using a three-wire version, a three-position switch will be required.
5. Feed the wires back through the hole and xxxx the light in place using the provided screws.
6. Attach the decorative bezel by lining up the cutouts and rotating until it snaps in place.
Please note that the manual does not provide specific details on the wiring connections, as it may vary depending on your specific electrical setup. It is recommended to consult a qualified electrician or follow local electrical codes for proper wiring connections.
If you have any further questions or need additional assistance, please refer to the manual or contact ITC Customer Support at the provided phone number or visit their website for warranty information.
Add New Comment