User Manual Q&AAnswer
Jan 24, 2025 - 04:31 AM
To assemble the bol com Electric Standing Desk, please follow these steps:
1. Loosen the 8 M6*10 screws that were attached before packing. Adjust the crossbar to the proper position and then tighten the 8 screws.
2. Attach the legs to the ends of the crossbar using 8 M6*12 screws.
3. Attach the foot margins to the legs using 8 M6*14 screws and tighten them with the provided 4mm hex spanner.
4. Attach the brackets to each end of the crossbar using 4 M6*12 screws.
5. Put the rubber cushions and plastic pads on the side brackets and crossbar.
6. Attach the brackets and the crossbar to the table top using 6 ST4.8*25 screws.
7. Attach the control box to the table top using 2 ST4.8*19 screws.
8. Attach the keypad to the table top using 2 ST3.5*19 screws.
9. Plug the cables from the two motors into the control box and connect the cable from the keypad.
For a visual reference, please consult the provided user manual for diagrams and illustrations.
Add New Comment