User Manual Q&AAnswer
Jan 24, 2025 - 04:19 AM
To wire the Rockustics SweetSpot speakers, follow these steps:
1. Locate the speaker wires on the underside of the speaker.
2. If necessary, strip and trim the wire ends.
3. Connect the two speaker wire channels to the input signal wire.
- Channel 1: Red wire is positive, Black wire is ground.
- Channel 2: Blue wire is positive, Brown wire is ground.
4. Use the supplied silicone wire nut to connect the leads.
- Rockustics recommends using 14ga or heavier Direct Burial cable for the connection between the amplifier and the speakers.
Note: The provided wire nuts are meant for permanent installation use only. If you are temporarily wiring the speakers, do not use these wire nuts. If you have used the wire nuts and need to re-wire your system, do not attempt to unscrew the nuts. Instead, clip the wires below the nut and follow the steps in the Basic Wiring section with a new pair of waterproof wire nuts.
For more detailed information and diagrams, please refer to the Rockustics SweetSpot Speakers Instruction Manual.
Add New Comment