User Manual Q&AAnswer
Jan 24, 2025 - 04:18 AM
To wire the Rockustics Planter Speakers, follow these steps:
1. Locate the speaker wires on the underside of the planter. If needed, trim the wire to the appropriate length and strip the wire ends.
2. Use the supplied silicone wire nut to connect the positive (red) leads of the speaker and input wires. Repeat this step with the negative (black) leads.
3. Rockustics recommends using 14ga or heavier direct burial cable for the connection between the amplifier and the speakers.
Note: The provided wire nuts are meant for permanent installation use only. If you are temporarily wiring the speakers, do not use these wire nuts. If you have used the wire nuts and need to re-wire your system, do not attempt to unscrew the nuts. Instead, clip the wires below the nut and follow the steps in the Basic Wiring & Set-Up section with a new pair of waterproof wire nuts.
For further assistance with installation or any other questions, you can contact your local sound contractor or the Rockustics/MSE Audio technical support team.
Add New Comment