User Manual Q&AAnswer
Jan 24, 2025 - 04:16 AM
To replace the cutting line on your BLACK+DECKER strimmer, follow these steps:
1. Make sure the tool is switched off and unplugged.
2. Remove the tape holding the cutting line to the spool housing.
3. Connect the female plug of a suitable extension cable to the power inlet.
4. Loop the cable through the cable restraint.
5. Insert the mains plug into a mains outlet.
6. Hold the tool in the correct position and gently swing the strimmer from side to side to trim the grass.
7. If the cutting line wears down, gently bump the unit on the ground while it is running to feed more line.
8. If the cutting line needs to be replaced, remove the spool cover from the housing by keeping the tabs depressed and pulling it off.
9. Remove the empty spool from the spool housing.
10. Clean any dirt and grass from the spool cover and housing.
11. Take a new spool of cutting line and unwind approximately 10 cm of the line.
12. Feed the cutting line through the eyelet on the spool.
13. Push the spool onto the drive shaft and rotate it slightly until it is seated. Make sure the cutting line is not trapped under the spool and that 10 cm of cutting line protrudes from the housing.
14. Align the tabs on the spool cover with the holes in the housing and push the cover onto the housing until it snaps securely into place.
15. If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade.
Please refer to the instruction manual for more detailed information and safety precautions.
Add New Comment