User Manual Q&AAnswer
Jan 23, 2025 - 11:36 PM
To install the EUROM Wall Designheat 2000R electric local space heater, follow these steps:
1. Select a suitable location for the heater, taking into account the minimum distances to walls and ceilings mentioned in the manual.
2. Ensure that the wall on which the heater will be hung is firm, flat, and made of non-inflammable material.
3. Drill two holes in the wall at the required locations, 39.4 cm apart and horizontal. Insert plugs and screws into the holes, allowing the screws to stick out by 10 mm.
4. Hang the heater over the screws using the hanging eyes, then slide it to the left and pull downwards.
5. Check if the heater is securely fixed to the wall. If necessary, insert the screws further into the plugs.
6. If you prefer to use a bracket for installation, place the bracket on top of the heater and mark the location of the hole on the wall. Drill a hole at the marked spot and insert a plug. Hang the heater in place and xxxx the bracket to the wall.
7. Ensure that the heater is preferably connected to a fixed electric socket. If a permanent connection is made, consult a qualified electrician.
8. Unroll the electrical cable fully and insert the plug into a suitable 220/240V socket.
9. Set the main switch of the heater to the ON position.
Please refer to the manual for detailed illustrations and additional safety instructions during installation.
Add New Comment