User Manual Q&AAnswer
Jan 23, 2025 - 11:26 PM
To connect your Jabra Engage 75 wireless earbuds with your Aastra desk phone for remote call control, please follow these steps:
1. Prerequisites:
- Jabra Link 14201-10 electronic hook switch (EHS) cable
- DHSG connection cable from Aastra
- Aastra 53i/55i/57i/6753i/6755i/6757i desk phone with firmware version 2.5.1.2000 or later
2. Connecting the headset:
- Plug the RJ10 connector (green) from the split end of the Aastra DHSG cable into the headset socket/port on the desk phone.
- Plug the RJ45 connector (yellow) from the split end of the Aastra DHSG cable into the socket/port for the expansion module on the desk phone.
- Plug the single end of the Aastra DHSG cable (blue) into the Aastra RJ45 adapter.
- Plug the single end of the Jabra Link 14201-10 cable (blue) into the free socket on the Aastra RJ45 adapter.
- Connect the 2-sided end of the Jabra Link 14201-10 cable to the Jabra base:
a. Plug the RJ10 (small) connector into the socket/port with the blue phone icon.
b. Plug the RJ45 (wide) connector into the socket marked AUX.
3. Configuring the headset:
- For the Jabra Engage 75, follow the onscreen setup wizard on the base.
- For the Jabra Engage 65, the initial setup is complete after connecting the cables.
- Refer to the user manual located in the Technical Documents section for more details on setting up the desk phone.
- Use Jabra Direct, a free computer application, to adjust features and functions according to personal preference or company requirements. Ensure your Jabra product is updated for the latest performance. Visit jabra.com/direct for more information.
Note: Additional setup information for your Jabra products:
- EHS cable/adapter type: DHSG.
- Clear dial tone switch: set to position "A".
- We recommend setting the microphone volume to "7" out of 13.
Phone settings:
- For Aastra desk phones with firmware version 2.5.1.2000, the DHSG mode is deactivated by default. Activate it by using Aastra.cfg or mac.cfg with the command "dhsg:1".
- Make sure you set the audio mode to "Headset/Speaker". Access the phone settings by navigating to Options > Default settings > Audio settings > Audio mode > Headset/Speaker.
Note: Remote call control is not possible if you are using an expansion keypad.
For more detailed information, please refer to the user manual provided by Jabra: [Jabra Engage 75 Wireless Earbuds User Manual](https://www.jabra.com.au/supportpages...)
Add New Comment