User Manual Q&AAnswer
Jan 23, 2025 - 09:18 PM
To set up and configure the FEP-1612W120 16-Port Fast Ethernet PoE Switch, follow the steps below:
1. Hardware Installation:
a. Connect one end of the power cord to the power socket on the switch and the other end to a power outlet.
b. Connect your network devices (computers, printers, etc.) to the switch using Ethernet cables.
c. If you have devices that require power over Ethernet (PoE), connect them to the PoE ports on the switch using Ethernet cables.
2. Network Configuration:
a. Connect a computer to one of the switch's Ethernet ports using an Ethernet cable.
b. Open a web browser and enter the default IP address of the switch (usually 192.168.0.1) in the address bar.
c. Enter the default username and password (usually admin/admin) to log in to the switch's web-based management interface.
3. Basic Configuration:
a. Once logged in, you can configure basic settings such as the switch's IP address, subnet mask, and default gateway.
b. Set up VLANs, if required, to segment your network.
c. Configure any additional features or settings according to your network requirements.
4. PoE Configuration:
a. If you have PoE devices connected to the switch, you can configure PoE settings such as power allocation, scheduling, and priority.
b. Enable or disable PoE on specific ports as needed.
5. Save and Apply Changes:
a. After making all the necessary configurations, save the settings and apply them to the switch.
b. Reboot the switch if prompted.
For more detailed instructions and advanced configuration options, refer to the user manual provided with the FEP-1612W120 16-Port Fast Ethernet PoE Switch.
Add New Comment