User Manual Q&AAnswer
Jan 23, 2025 - 10:19 AM
To install the VSYSTO T3 Upgrade 3CH Truck Dash Camera, please follow the steps below:
1. Determine the best location for mounting the dash camera. It is recommended to mount it on the windshield near the center or close to it for a consistent field of view for the sides of the car.
2. Clean the mounting surface thoroughly to ensure proper adhesion of the adhesive mount.
3. Remove the protective film from the adhesive mount and firmly press it onto the windshield.
4. Connect the power cable to the dash camera and route it along the windshield and down to the vehicle's power source. You can use the included adhesive clips to secure the cable in place.
5. Connect the power cable to the vehicle's power source, such as the cigarette lighter socket. The dash camera will automatically turn on and start recording when the vehicle's ignition is turned on.
6. Adjust the angle of the dash camera to ensure it captures the desired view. You can use the swivel mount to adjust the camera's position.
7. Optionally, you can connect the included side and rear cameras to the main dash camera using the provided cables. These cameras can be mounted on the sides or rear of the vehicle to capture additional angles.
8. Once everything is connected and mounted, test the dash camera to ensure it is functioning properly. You should see the video feed on the dash camera's screen or connected monitor.
Please refer to the VSYSTO T3 Upgrade 3CH Truck Dash Camera Instruction Manual for more detailed installation instructions and troubleshooting tips.
Add New Comment