Answer
Jan 23, 2025 - 05:16 AM
To change the plastic filament in the 3Doodler Create+ Printing Pen, please follow these steps:
1. Make sure the pen is turned on and heated up. The light on the pen will turn blue when it is ready.
2. Double click either the fast or slow speed button to activate the reverse feature. The light will start flashing to indicate that the plastic is reversing.
3. Once the plastic stops reversing, gently pull on the back of the strand to remove it from the pen.
4. If the plastic is too short to reverse, you can use the unblocking tool provided in the box. While the pen is on and hot, insert the unblocking tool through the open front end of the pen and gently push any excess plastic out through the back of the pen.
5. Once the old plastic filament is removed, you can insert a new strand of plastic into the plastic loading port at the back of the pen.
6. Wait for the pen to heat up and the light to indicate that it is ready for doodling.
7. Start extruding the new plastic filament by clicking either the fast or slow speed button once.
Please refer to the instruction manual for more detailed information and troubleshooting tips.
Add New Comment