User Manual Q&AAnswer
Jan 23, 2025 - 04:24 AM
To install the Eaton 1498D66G15 Molded Case Circuit Breaker Accessory Handle Mechanism, please follow the instructions below:
1. Ensure that the power to the circuit breaker is turned off before starting the installation process.
2. Remove the existing handle mechanism, if applicable, by loosening the screws or fasteners that secure it to the circuit breaker.
3. Take the Eaton 1498D66G15 handle mechanism and align it with the designated slots or holes on the circuit breaker. Make sure the mechanism is positioned correctly.
4. Insert the screws or fasteners provided with the handle mechanism into the corresponding holes on the circuit breaker. Tighten them securely to ensure proper installation.
5. Once the handle mechanism is securely attached, double-check that it is aligned properly and functions smoothly. Ensure that the handle can move freely to turn the circuit breaker on and off.
6. After confirming the proper installation, restore power to the circuit breaker and test the functionality of the handle mechanism.
Please note that these instructions are a general guideline. For specific installation details and any additional precautions, please refer to the Eaton 1498D66G15 Molded Case Circuit Breaker Accessory Handle Mechanism's instruction manual or contact the manufacturer for further assistance.
Add New Comment