How do I install the AMAX LED-RSM8DL WT Radar Sensor Integrated LED Recessed Light Kit? (AMAX LED-RSM8DL WT Radar Sensor LED Light Kit User Manual)

Answer

manuals.plus

Jan 23, 2025 - 04:14 AM


To install the AMAX LED-RSM8DL WT Radar Sensor Integrated LED Recessed Light Kit, follow these steps:

1. Turn off the electrical power before starting the installation of the light fixture. This is important for safety.

2. Make sure you have the necessary tools and materials required for the installation.

3. Consult a certified electrician familiar with local municipal codes and requirements to ensure proper installation.

4. Prior to installation, install a mounting plate into the electrical junction box using mounting screws. Drive the screws completely to the end of the junction box.

5. Connect the supply wires to the wires on the fixture using wire nuts. Connect white to white, black to black, and ground wire to ground wire for proper grounding connection.

6. Complete the installation by pushing the fixture spring clips towards the opening in the mounting plate installed on the junction box.

7. The radar sensor integrated in the light kit turns off the light after 17 seconds of no detection and turns it back on when the user re-enters the workplace from 4.5-5.5 yards away.

Please note that wet-rated lighting fixtures are designed for direct exposure to water, such as outdoor lights. However, it is important to ensure that water does not enter the junction box, as it can pose an electrical hazard. If you have any further questions or concerns, you can contact customer service at 888-945-5221.