User Manual Q&AAnswer
Jan 23, 2025 - 03:35 AM
To charge the battery pack for the BEZGAR HM124 Brushless High Speed RC Truck, follow these steps:
1. Use the specified charger provided in the box. The charger is a balance USB charger.
2. Connect the USB cable of the charger to a power source.
3. Slide and remove the battery cover from the transmitter (radio controller).
4. Install three AA-size batteries (1.5V each) into the battery compartment of the transmitter. Make sure to observe the correct polarity when installing the batteries.
5. Connect the battery pack to the charger. The charger's red LED (Power LED) will be solid on as long as it is plugged in, even when no battery is loaded.
6. During charging, the red LED will remain solid on, and the green LED (Charging LED) will flash slowly.
7. The green LED will become solid on after the battery pack has been fully charged.
8. It will take approximately 4.5-5 hours to fully charge a 7.4V, 1500mAh or 1600mAh Li-ion or Li-Po battery pack. You can use a smartphone AC power adapter (5V, 2A) to reduce the charging period.
Important Safety Precautions:
- Do not charge the battery pack unattended.
- Do not use damaged or leaky batteries or a damaged charger.
- Children should not charge the battery without close supervision from adults.
- Keep the charging area dry, clean, and safe.
- Do not use a wet USB cable or expose it to heat and humidity.
- Keep the charger and batteries out of children's reach when charging.
Please refer to the instruction manual for more detailed information and safety precautions.
Add New Comment