User Manual Q&AAnswer
Jan 23, 2025 - 03:30 AM
To install the RITTAL 5085511 Inlet-Outlet Filter, please follow the instructions below:
1. Ensure that the power to the equipment is turned off and unplugged before starting the installation process.
2. Locate the desired location for the filter on the equipment. It is recommended to install the filter on the side or rear panels to allow for efficient airflow.
3. Measure the dimensions of the filter and mark the corresponding area on the panel where it will be installed. Use a pencil or marker to make the markings.
4. Using a suitable cutting tool, carefully cut out the marked area on the panel. Take caution to avoid any damage to the equipment or yourself during this process.
5. Once the opening is cut, remove any sharp edges or burrs from the cut area to ensure a smooth and safe installation.
6. Take the RITTAL 5085511 Inlet-Outlet Filter and align it with the opening on the panel. Ensure that the filter is centered and level before proceeding.
7. Using the provided screws or mounting hardware, secure the filter onto the panel. Tighten the screws firmly, but be careful not to overtighten and damage the filter or panel.
8. Double-check the installation to ensure that the filter is securely attached and properly aligned with the opening.
9. Once the filter is installed, you can connect the power supply and turn on the equipment.
Please note that these instructions are a general guideline, and it is always recommended to refer to the specific installation manual provided with the RITTAL 5085511 Inlet-Outlet Filter for detailed and accurate instructions tailored to your specific model.
Add New Comment