User Manual Q&AAnswer
Jan 23, 2025 - 03:08 AM
To install the Eaton MT3800T Molded Case Circuit Breaker Accessory Trip Unit, please follow the steps outlined below:
1. Ensure that the power to the circuit breaker is turned off before starting the installation process.
2. Remove the cover from the circuit breaker by loosening the screws or clips that hold it in place. Set the cover aside in a safe location.
3. Locate the trip unit slot on the circuit breaker. It is typically located near the front or top of the breaker.
4. Align the accessory trip unit with the slot on the circuit breaker. Make sure the pins on the trip unit match the corresponding holes in the slot.
5. Gently push the trip unit into the slot until it is fully seated. Ensure that it is securely in place.
6. Reattach the cover to the circuit breaker by aligning it with the breaker and tightening the screws or clips.
7. Once the trip unit is installed, you can connect the necessary wiring according to the manufacturer's instructions. Refer to the wiring diagram provided in the manual for proper connections.
8. After the wiring is complete, double-check all connections to ensure they are secure and properly tightened.
9. Finally, turn on the power to the circuit breaker and test the functionality of the trip unit. Follow the testing procedures outlined in the manual to verify its operation.
Please note that these instructions are a general guide, and it is important to refer to the specific manual provided by Eaton for detailed installation instructions and safety precautions.
Add New Comment