User Manual Q&AAnswer
Jan 22, 2025 - 11:25 PM
To install the GC1-S Waterproof Gimbal 4K Camera on your SplashDrone 4, follow these steps:
1. Unscrew and remove the gimbal port cover plate on the drone using a hex screwdriver.
2. Plug the gimbal connector into the drone's gimbal port and secure it with a screwdriver.
3. Align the holes on the base of the gimbal with the bottom of the drone and xxxx it in place to mount the gimbal. Make sure the camera is pointing towards the front of the drone.
For more detailed instructions and illustrations, please refer to the "Installation" section of the user guide.
Note: It is important to handle the gimbal camera with care during takeoff and landing to avoid any damage. Additionally, after using the camera in seawater, it is recommended to thoroughly rinse it with clean fresh water before it dries out to prevent any corrosion or damage.
Add New Comment