User Manual Q&AAnswer
Jan 22, 2025 - 10:59 PM
To adjust the temperature on the Aktobis AG WDH-BGP02 2 kW Fan Heater, follow these steps:
1. Plug the heater into a power socket.
2. Locate the operating power adjustment xxxx on the left-hand side of the control panel. This xxxx allows you to select the desired unit power.
- "Off" position: The heater is turned off.
- "Fan operation" position: The heater operates as a cold fan.
- "Level 1" position: Medium operating strength with 1,350 W heating power.
- "Level 2" position: Highest operating strength with 2,000 W heating power.
3. Once you have selected the desired unit power, turn the right-hand xxxx , which is the stepless thermostat control dial, to set the desired temperature switch-off point.
- The thermostat control dial has a range of 0 to 45°C.
- Start by turning the dial to the highest temperature (MAX.) and let the heater run until your desired temperature is reached.
- Then, gradually turn the dial downwards towards the minimum until the heating function switches off automatically.
- Leave the control dial in this position, and the heater will automatically start heating when the room gets colder and switch off when the adjusted temperature is reached again.
Note: At high temperatures, a short fan run-on may occur. The fan will switch off immediately once the internal thermostat or heating coil has cooled down sufficiently.
Remember to turn the thermostat control xxxx to the minimum (min.) position and allow the heater to run in fan mode for about 5 minutes to cool down before switching off the appliance completely.
Please refer to the user guide for additional safety instructions, cleaning and storage guidelines, troubleshooting tips, and warranty information.
Add New Comment