User Manual Q&AAnswer
Jan 22, 2025 - 10:32 PM
Sure! Here are the step-by-step instructions for installing the EVGA GT Series GOLD 1000W/1300W Power Supply:
1. Remove the power supply from its packaging.
2. (Optional) Use the provided PSU testing tool to connect the 24-Pin cable to the PSU and attach the testing tool to the 24-Pin cable. Connect the ATX power cable to the PSU and plug the PWR cable into the outlet or surge protector/UPS you plan to use. Turn the power switch to the ON position. (Note: This step is optional and can be used for testing or bleeding/draining water cooling components.)
3. Use the screws provided with your case to install the power supply into your computer. It is recommended to install the power supply with the fan facing down. However, if your case places the power supply at the bottom without ventilation holes, it may be best to install it with the fan facing up for better efficiency and reliability.
4. Connect the 24-Pin ATX cable to the PSU and the motherboard.
5. Connect the 4+4-Pin EPS12V cable to the motherboard. If you plan on extreme overclocking or have a dual CPU motherboard, you can connect the second 4+4-Pin EPS12V cable.
6. Connect the 6/6+2-Pin PCI-E cables to your graphics card(s). Make sure not to plug an 8-Pin PCI-E cable into a 6-Pin connector without detaching the two extra pins.
7. Connect SATA power cables to all data drives or optical drives (hard drives, solid-state drives, optical drives).
8. Connect the peripheral "Molex" 4-Pin connectors for fans, pumps, legacy components, and other devices/adapters.
9. Connect the AC power cord to your power supply and to the wall. Check all connections to ensure a solid connection and turn the power switch on the power supply to the ON position.
Please refer to the EVGA GT Series GOLD 1000W/1300W Power Supply User Manual for more detailed information and illustrations.
Add New Comment