User Manual Q&AAnswer
Jan 22, 2025 - 09:24 PM
Sure! Here are the step-by-step instructions for setting up the Cel-Fi GO X MIMO kit:
1. Read the instruction manual thoroughly: Before you begin the installation, it's important to read the instruction manual provided with the kit. This will give you a complete understanding of the installation process and ensure that you set up the kit correctly.
2. Check signal strength outside the building: Before installing the kit, make sure you have at least 1 bar of usable signal outside or on the roof of the building. You should be able to place a call and use data reliably. If you don't have 1 bar or you're unsure, contact the support team for assistance.
3. Understand compatibility: The Cel-Fi GO X is compatible with AT&T 3G and 4G LTE signals on Bands 2, 4, 5, and 12, T-Mobile 3G and 4G LTE signals on Bands 2, 4, 5, and 12, and Verizon 4G LTE signals on Bands 2, 4, 5, and 13. It also supports 5G-DSS on the same bands, except for T-Mobile 5G. Make sure your carrier and bands are supported before proceeding with the installation.
4. Download the Wave app: Download the Wave app to your phone by visiting waveform.com/waveapp. This app will be used to set up and configure the Cel-Fi GO X boosters.
5. Set up the GO X boosters: Plug each GO X booster into a power outlet to power them on. Download and open the Wave app on your phone while keeping it within 4 feet of both boosters. The app will guide you through the pairing process and allow you to select the carrier you want to boost. Make sure both boosters have the same carrier settings.
6. Position and aim the outdoor antenna: Use the Wave app's Antenna Position Test to find the best location and direction for the outdoor antenna. Test multiple positions and capture the results in the app. Ideally, you want a location with a score of 115 or higher. Secure the outdoor antenna temporarily in the chosen location.
7. Install the indoor antennas: Depending on the kit you purchased, you will have either dome or panel antennas. Panel antennas should be installed on a wall near the perimeter of the coverage area, while dome antennas should be installed in the ceiling centrally to the area you want to cover. Make sure to provide enough separation between the indoor and outdoor antennas to avoid oscillation.
8. Connect the cables: Connect the coaxial cables provided in the kit to the appropriate ports on the boosters and antennas. Follow the instructions in the manual for proper cable connections.
9. Test the performance: Once everything is connected, test the performance of the system. Make voice calls and run speed tests to check the signal strength and data rates. If everything is working well, you can proceed to a permanent installation. If not, contact the support team for assistance.
10. Finalize the installation: If the temporary setup is successful, you can proceed with a permanent installation. Drill holes, secure the antennas, and run the cables in a more permanent manner. Make sure to weatherproof outdoor connections and consider surge protection and grounding for added safety.
11. Provide feedback: Waveform values customer feedback and encourages you to share your installation experience and system performance. You can contact them via email or phone to provide feedback or ask any additional questions.
Remember, these instructions are a summary of the information provided in the Cel-Fi GO X MIMO Instruction Manual. For more detailed instructions and troubleshooting guidance, refer to the manual or contact the Waveform support team for assistance.
Add New Comment