User Manual Q&AAnswer
Jan 22, 2025 - 08:41 PM
To install the PRO ARMOR Polaris RZR XP1000/2015 900S Rock Sliders, follow these steps:
1. Begin by removing any dirt or obstructions that may interfere with the installation. Ensure that all mounting holes and surfaces are clear.
2. Assemble the supplied expansion anchors [ITEM 1] with the rock slider. Insert the bolt, washer, and sleeve into the mounting hole first. The flat surfaces of the sleeve of the expansion anchor should fit into the groove in the mounting hole of the rock slider. Then, thread the nut on the back side against the fingers of the sleeve. The flat surfaces of the nut should fit into the groove in the sleeve and create a snug fit.
3. Place the rock slider with the expansion anchors onto the vehicle. Make sure the sleeves of the expansion anchors are still seated properly in the grooves in the mounting holes of the rock slider before proceeding to tighten the anchors. Apply constant inward pressure on the anchors as you tighten. It may be helpful for another person to hold the rock slider in place while you go around and evenly torque down the three anchors. Do not overtighten as it may shear the bolt in the expansion anchor.
4. Repeat the steps for the other side. The installation is now complete.
Please note that the tools required for installation are a 1/4" drive ratchet, 6 in. extension, and a 13mm socket.
It is important to ensure that all hardware and components are securely installed before operating the vehicle to prevent any damage. The effectiveness of the equipment is directly related to the manner in which it is installed, used, and maintained. Proper installation is the responsibility of the installer.
For further information on installation instructions and warnings, you can visit the PRO ARMOR website at www.proarmor.com or contact their customer service at 1-888-31-ARMOR.
Add New Comment