How do I adjust the tension of the cable on the FITFIU GYM-100 Multi-Station Home Gym? (FITFIU GYM-100-Maquina Musculacion Instruction Manual)

Answer

manuals.plus

Jan 22, 2025 - 01:19 AM


To adjust the tension of the cable on the FITFIU GYM-100 Multi-Station Home Gym, follow these steps:

1. First, make sure the machine is fully assembled and all bolts and nylon nuts are tightened properly.

2. Check the tension of the cable by looking at the gap between the top plate and the weight stack. There should be a 3-5mm gap when the cable is at the correct tension.

3. If the cable is slightly loose, you can tighten it by tightening the bolt on top of the weight stack. Use a wrench or spanner to turn the bolt clockwise until the desired tension is achieved.

4. If the cable is too loose, you can adjust the length of the spiral chain. Locate the snap link on the spiral chain and detach it from the weight stack.

5. Adjust the length of the spiral chain by removing or adding links as needed. Each link corresponds to a certain amount of tension. Remove links to increase tension or add links to decrease tension.

6. Once you have adjusted the length of the spiral chain, reattach the snap link to the weight stack.

7. Test the tension of the cable again by checking the gap between the top plate and the weight stack. Make further adjustments if necessary.

Note: It is important to ensure that the cable tension is properly adjusted for safe and effective use of the machine. Always follow the manufacturer's instructions and guidelines provided in the manual.