User Manual Q&AAnswer
Jan 22, 2025 - 12:55 AM
To attach the Stinger TXTRB10BB Subwoofer Enclosure Port Module to the TXTRB10 subwoofer enclosure, please follow these steps:
1. Unscrew the eight #2 Philips speaker mounting screws and remove the subwoofer from the TXTRB10 subwoofer enclosure.
2. Unscrew the side panel from the TXTRB10 subwoofer enclosure using 4mm and 5mm Allen wrenches. Push out the side panel from inside the enclosure.
3. Align and attach the foam gasket to the TXTRB10BB (Port).
4. Align the TXTRB10BB (Port) next to the TXTRB10 (Enclosure). Place a rubber washer on the four inner bolts. From inside the enclosure, align the four bolts through the enclosure into the threaded holes on the port. Tighten using a 10mm socket.
5. Install two additional bolts on the bottom side of the enclosure stand.
6. Reconnect the speaker wire from the TXTRB10 enclosure to the subwoofer the same way as before it was removed.
7. Reinstall the subwoofer using a #2 Philips screwdriver.
Please refer to the owner's manual for visual illustrations and additional information on attaching the port module.
Add New Comment