User Manual Q&AAnswer
Jan 22, 2025 - 12:27 AM
Cleaning and replacing the filter cartridge in the is an important maintenance task to ensure clean and clear water. Here are the steps to clean and replace the filter cartridge:
1. Turn off the spa: Before starting any maintenance tasks, make sure to turn off the spa and unplug it from the power source.
2. Locate the filter cartridge: The filter cartridge is usually located inside the spa, near the pump unit. It is housed in a filter case.
3. Unscrew the filter case: Turn the filter case counter-clockwise to unscrew it and remove the filter cartridge from the case.
4. Rinse the filter cartridge: Use a garden hose to thoroughly rinse off the filter cartridge. Make sure to remove any dirt, debris, or contaminants that may have accumulated on the filter.
5. Check the condition of the filter cartridge: Inspect the filter cartridge for any signs of damage or wear. If the filter cartridge is dirty, discolored, or damaged, it should be replaced.
6. Replace the filter cartridge (if necessary): If the filter cartridge is in poor condition, it is recommended to replace it with a new one. Follow the manufacturer's instructions for the specific replacement cartridge.
7. Reassemble the filter case: Once the filter cartridge has been cleaned or replaced, put it back into the filter case. xxxx the filter case back into place by turning it clockwise.
8. Restart the spa: Plug the spa back into the power source and turn it on. The filtration system should start working again.
Remember to clean or replace the filter cartridge regularly, approximately every 150 hours of filtration operation or every 1 to 2 months, to maintain optimal water quality in your EXIT TOYS Silver Classic Spa.
Add New Comment