User Manual Q&AAnswer
Jan 21, 2025 - 11:04 PM
To connect the power supply cable to the GEWiSS Joinon Wallbox I-Con Range Electric Vehicle Charging Wallbox, follow these steps:
1. Locate the two terminal blocks on the Wallbox: the electronic board power supply and the main power supply.
2. The electronic board can be powered in two different ways:
a) Via an allocated line allowing a possible power supply from the UPS.
b) Taking L1 and N from the main power supply.
3. If you have an allocated line for the electronic board power supply, connect the power supply cable from the UPS to the corresponding terminal block.
4. If you are using the main power supply, connect the L1 (line) and N (neutral) wires from the main power supply to the corresponding terminal block on the Wallbox.
5. Ensure that the power supply cable is securely connected to the terminal blocks, following the manufacturer's instructions and any applicable electrical codes or regulations.
6. Once the power supply cable is connected, you can proceed with the rest of the installation process as outlined in the Installation Guide.
If you have any further questions or need additional assistance, you can contact GEWISS directly using the provided contact details:
GEWISS S.p.A.
Via A.Volta, 1
IT-24069 Cenate Sotto (BG)
Italy
Tel: +39 035 946 111
E-mail: qualitymarks@gewiss.com
Add New Comment