User Manual Q&AAnswer
Jan 21, 2025 - 10:34 PM
To connect the INTEGRAL-WA2 amplifier to your speakers, follow these steps:
1. Identify the speaker outputs on the bottom panel of the amplifier. There are two sets of connectors labeled "Right Channel R+" and "Left Channel L+". These are terminal block type connectors with a 3.5mm pitch.
2. Connect the positive terminal of your right speaker to the "Right Channel R+" connector and the positive terminal of your left speaker to the "Left Channel L+" connector.
3. Connect the negative terminals of your speakers to the corresponding negative terminals on your amplifier. These are labeled "R-" and "L-" on the terminal block connectors.
4. Ensure that all connections are secure and properly tightened.
Note: The INTEGRAL-WA2 amplifier supports 8-ohm and 4-ohm loads per channel. Make sure your speakers match the impedance requirements of the amplifier for optimal performance.
For more detailed instructions and illustrations, please refer to the "Connections" section of the user manual.
Add New Comment